EMT Practice Test

1. Question Content...


Question List

Question1: Which of the following statements regarding the stateful inspection firewall is true?

Question2: An engineer sets the CAPWAP heartbeat detection interval to 20 of the active link before an active/standby switchover occurs?

Question3: BFD control packets are encapsulated in UDP packets for transmission. What is the destination port number of multi-hop BFD control packets?

Question4: Which of the following statements about multicast packet forwarding is true?

Question5: According to BGP route selection rules, the route with the higher Local_Pref is preferred.

Question6: Which of the following routing protocols support the default route through command configuration?

Question7: Preferences of routing protocols determine the sequence In which a router selects a route among routes to the same destination /earned through different routing protocols.

Question8: A monitoring plane usually comprises the monitoring units of main control boards and interface boards. This plane can monitor the system environment independently. Which of the following environment monitoring functions can be provided by the monitoring plane?

Question9: The Interface \P address and VRRP virtual IP address can be the same.

Question10: Which of the following statements is false, based on the following IGMP information on an interface of RTA?

Question11: Which of the following statements regarding an IP prefix are true?

Question12: Regarding the route-policy set-cost configuration below, which of the following statements is true?

Question13: The traffic limiting policy feature only supports the number of connections initiated by the specified IP or the number of connections received.

Question14: When two routers exchange LSDB information using DD packets, a master/slave relationship is formed first, the router with a larger router ID is the master, and determine the MS bit.

Question15: To prevent inter-area routing loops, OSPF does not allow advertising routing information between two non-backbone areas and allows sing routing information only within an area or between the backbone area and a non-backbone area. Therefore, each ABR must be connected to the backbone area.

Question16: When a routing policy is used to filter routes, which of the following route prefixes will be denied by the IP prefix below?

Question17: A local router runs IS-IS and its command output is shown in the following figure. Which of the following statements is true?

Question18: ON a stateful inspection Firewall where there is no session table, when the status detection mechanism is enabled and the second packet (CYN+ACK) of 3-way hadshakes reaches the firewall. Which of the following statements is true?

Question19: What is the correct procedure for a VLAN pool to assign terminals to VLANs.

Question20: In BGP, the origin attribute of the routes imported using the import-route command is incomplete.